When using the P0V0 Modular Blower with the Variable Speed Outdoor Units, a relay panel must be used.
Correct
Incorrect
Question 2 of 10
2. Question
The P0V0 Modular Blower must be configured through the IFC at the time of installation.
Correct
Incorrect
Question 3 of 10
3. Question
Connecting 24VAC to the W1 or W2 terminals on the IFC will cause error codes and the P0V0 Modular Blower will not operate.
Correct
Incorrect
Question 4 of 10
4. Question
The P0V0 Modular Blower is designed to be used with supplemental heat strips.
Correct
Incorrect
Question 5 of 10
5. Question
You can find a video to assist you with diagnosing and troubleshooting the serial port motor on the P0V0 Modular Blower at www.fieldtechhelp.com.
Correct
Incorrect
Question 6 of 10
6. Question
The P0V0 Modular Blower is rated above Total System Statics of 0.09” W.C.
Correct
Incorrect
Question 7 of 10
7. Question
The P0V0 Modular Blower is a 4-way multi poise unit.
Correct
Incorrect
Question 8 of 10
8. Question
The BK terminal on the IFC is only used with a Trane Thermostat with a BK terminal and when the BK jumper has been cut on the IFC.
Correct
Incorrect
Question 9 of 10
9. Question
A single side return can be used on the P0V0 Modular Blower for 2000 CFM operation.
Correct
Incorrect
Question 10 of 10
10. Question
The P0V0 Modular Blower can be used with either Heat Pump or AC condensers.
Correct
Incorrect
Report
Block Member?
Please confirm you want to block this member.
You will no longer be able to:
See blocked member's posts
Mention this member in posts
Invite this member to groups
Message this member
Add this member as a connection
Please note:
This action will also remove this member from your connections and send a report to the site admin.
Please allow a few minutes for this process to complete.
